Safety Advice - welltherm RL0606 Bedienungsanleitung

V3.5 28.07.2014

1. Safety advice

1.1. The heater must not be covered (for example by textiles or similar)!
1.2. The heater can be used by children over 8 years and by persons with defizits in the
physical, sensorical or mental power or which are short of experience and science if they
are supervised or are instructed about the safely usage of the gadget and have understood
the resulting dangers. Children are not allowed to play with the heater nor to clean or to
service it without supervision.
Children under 3 years have to be kept away from the gadget or have to be supervised all
the time.
Children over 3 years and up to 8 years are just allowed to switch the gadget on and off if
they are supervised and are teached to handle the gadget safely and have understood the
resulting danger.
The basics for this is the mounting and the installation of the heater in the normal position
of usage.
Children over3 years and under 8 years must not connect the plug to the power supply,
control the product and/or do the customer maintenance.
DANGER: Some parts of the product will reach high temperatures and may cause burns!
Special care has to be taken by the presence of children and of persons who need
protection.
1.3. Welltherm infrared heating panels are designed for use with AC 230 V, 50 Hz.
If you intend to install several heaters please contact an electrically skilled person to check
the suitability of the electrical installation!
1.4. Welltherm infrared heating panels type RA / RL are not equipped with an inbuilt
temperature controller. Therefore it is recommended not to use the heating element in very
small rooms with inhabitants which are not able to leave the room on their own!
1.5. To avoid the danger of electrical shock the Welltherm infrared panel heater must not be
opened, modified or repaired by the user!
If the power cord is damaged it has to be replaced by the specialists of company Welltherm
GmbH or by an skilled electrician!
1.6. The glass material is a security glass. This is mechanically more stable and will break
in small, less sharp edged parts. Nevertheless the place of installation should be chosen
carefully so that no people can be harmed by a potential damage of the glass!
Attention: avoid mechanical stress on the glass!
If the glass is damaged immediately
- separate it from the electrical network and don't connect it again!
- unmount the panel heater to avoid the risk of downfalling parts!
GB
ATTENTION: Danger of overheating and fire hazard!
Manual_ESG_DE_GB_Rev. 3.5 | Welltherm 10