Klarstein MIRO Handbuch Seite 20

EN
20
Maintenance
• Have the lamps replaced by a specialist.
• When you move the unit, hold it by the sides or on the floor. Do not hold it by the
edges of the top
• The unit should be serviced by an authorized technician and only original spare
parts should be used. Never attempt to repair the device yourself. Repairs by
inexperienced persons can lead to injuries or serious malfunctions.
• If the unit will not be used for a long time, disconnect it from the power supply.
Remove all food and clean the unit. Leave the door open to avoid unpleasant
odours.
TROUBLESHOOTING
Problem
Appliance does not work.
The food is too warm.
Appliance cools too much. Temperature is set too cold. Turn the temperature
Possible cause
Temperature regulation
knob is set at number "0".
Mains plug is not plugged
in or is loose
Fuse has blown or is
defective
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Solution
Set the knob at other
number to switch on the
appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Please look in the initial
Temperature Setting
section.
Open the door only as
long as necessary.
Turn the temperature
regulation to a colder
setting temporarily.
Please look in the
installation location
section.
regulation knob to a
warmer setting temporarily.