Cleaning Before Use - hanseatic HCDA19090DI Gebrauchsanleitung

5. Level out any unevenness on the ground
using both of the front screw feet (12).
6. Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
7. Repeat the adjustment until the appliance
is upright and secure. The appliance should
not wobble when opening the doors.
About climate categories
• Always ensure the prescribed ambient temperature is maintained (see "Intended use" on
page EN-4).
Climate category means that the appliance is intended for operation at the specified ambient
temperature.
Zone designation
extended temperate zone
temperate zone
subtropical zone
tropical zone
If the room temperature drops significantly below this, the appliance will not switch on as often.
This indicates that an unwelcome increase in temperature may occur.

Cleaning before use

In order to remove the odour which is present
in all new appliances, wipe the fridge com-
(12)
partment and freezer zone out prior to first
use with a solution made from 100 ml vinegar
and 200 ml water. Then wipe it out with clean
water and dry all of the parts off afterwards.
(12)
Code Definition
SN This cooling appliance is designed for use at ambient
temperatures of +10 °C to +32 °C.
N This cooling appliance is designed for use at ambient
temperatures of +16 °C to +32 °C.
ST This cooling appliance is designed for use at ambient
temperatures of +16 °C to +38 °C.
T This cooling appliance is designed for use at ambient
temperatures of +16 °C to +43 °C.
Page EN-27
Start-up