Part Names; Turning Off The Power - Sharp MX-B350W Starthandbuch

Storing toner cartridges
Store a new toner cartridge box horizontally with the top side
up. Do not store a toner cartridge standing on end. If stored
standing on end, the toner may not distribute well even after
shaking the cartridge vigorously, and will remain inside the
cartridge without flowing out.
• Store the toner in a location that is cooler than 40°C (104°F).
Storage in a hot location may cause the toner in the
cartridge to solidify.
• Please use SHARP-recommended toner cartridges. If toner
cartridges other than SHARP-recommended toner cartridges are
used, the machine may not attain full quality and performance
and there is a risk of damage to the machine.
Supply of spare parts and consumables
The supply of spare parts for repair of the machine is
guaranteed for at least 7 years following the termination of
production. Spare parts are those parts of the machine which
may break down within the scope of the ordinary use of the
product, whereas those parts which normally exceed the life of
the product are not to be considered as spare parts.
Consumables too, are available for 7 years following the
termination of production.

PART NAMES

(1) (2)
(6) (7) (8)
(1) Output tray (exit tray cabinet)
(2) Automatic document feeder
(3) Operation panel
(4) USB port (A type)
(5) Bypass tray
(6) Handle
(7) Tray 1
(8) Tray 2 (when a 600-sheet paper feed unit is
installed)*
(9) Front cover
* Optional
(3) (4) (5)
(9)
TURNING ON THE
POWER
This section describes how to turn on/off the machine's power
and how to restart the machine. The power switch is located on
the left side of the machine.
The main power switch
Turning on the power
Turn the main power switch to the "

Turning off the power

Turn the main power switch to the "
Restart the machine
Turn the main power switch off and then on.
Turn off the main power switch and unplug the power
cord if you suspect a machine failure, if there is a bad
thunderstorm nearby, or when you are moving the
machine.
• When using the fax function, always keep the main
power switch in the "
• Print and other functions cannot be used during a
brief period of time after the power is turned on or
after the machine is wakened from sleep mode.
This time is required to allow the machine to
prepare for normal printing, and is called the
warmup time.
" position.
" position.
" position.
5