Makita DUR365U Bedienungsanleitung Seite 14

ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying out
any work on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the handle
Fig.9
Insert the shaft of the handle into the grip. Align the
screw hole in the grip with the one in the shaft. Tighten
the screw securely.
Fig.10
Place handle between handle clamp and handle holder.
Adjust the handle to an angle that provides a
comfortable working position and then secure by firmly
hand-tightening knob.
Installing the guard
WARNING:
Never use the tool without the guard illustrated
•
in place. Failure to do so can cause serious
personal injury.
Always use the tool with the approved combination
•
of the safety equipments. Otherwise contact with a
cutting tool may cause serious injury.
Permitted combination for the cutting tool and the
•
guard may differ from country to country. Follow
your region's regulations.
For metal blade
Fig.11
Fig.12
For nylon cutting head or plastic blade
CAUTION:
Take care not to injure yourself on the cutter for
•
cutting the nylon cord when installing nylon cutting
head or plastic blade.
Fig.13
Fig.14
Align the clamp on the pipe with the protector. And
tighten them with bolts.
Installing the metal blade
(optional accessory)
WARNING:
The outside diameter of the metal blade must
•
be 230 mm. Never use any blade exceeding 230
mm in outside diameter.
CAUTION:
The metal blade must be well polished, free of
•
cracks or breakage. Polish or replace the metal
blade every three hours of operation.
Always wear gloves when handling the metal
•
blade.
Always attach the blade cover when the tool is not
•
in use or is being transported.
The metal blade-fastening nut (with spring washer)
•
wears out in course of time. If there appears any
wear or deformation on the spring washer, replace
the nut. Ask your local authorized service center to
order it.
Replace the cup in case of crack or breakage due
•
to attrition.
NOTICE:
Be sure to use genuine Makita metal blade.
•
Turn the tool upside down so that you can replace the
metal blade easily.
Fig.15
Mount the metal blade onto the shaft so that the guide
of the receive washer fits in the arbor hole in the metal
blade. Install the clamp washer and secure the metal
blade with the hex nut with 13 to 23 Nm of tightening
torque during holding the receive washer with hex
wrench.
Fig.16
To dismount the metal blade, insert the hex wrench
through the hole on the protector cover and the gear
case. Rotate the receive washer until it is locked with
the hex wrench. Loosen the hex nut (left-hand thread)
with the socket wrench and remove the nut, clamp
washer and hex wrench.
Fig.17
Make sure that the blade is the left way up.
Installing nylon cutting head or plastic blade
(optional accessory)
CAUTION:
If the nylon cutting head / plastic blade
•
accidentally impacts a rock or hard object
during operation, stop the tool and inspect for
any damage. If the nylon cutting head / plastic
blade is damaged, replace it immediately. Use
of a damaged cutting tool could result in serious
personal injury.
NOTICE:
Be sure to use genuine Makita nylon cutting head /
•
plastic blade.
Turn the tool upside down so that you can replace the
nylon cutting head easily.
Fig.18
14