ASROCK X299 Killer SLI/ac Bedienungsanleitung Seite 32

2.8 M.2_SSD (NGFF) Module Installation Guide
The M.2, also known as the Next Generation Form Factor (NGFF), is a small size and
versatile card edge connector that aims to replace mPCIe and mSATA. The Ultra M.2
Socket can accommodate either a M.2 SATA3 6.0 Gb/s module or a M.2 PCI Express
module up to Gen3 x4 (32 Gb/s).
* If M2_1 is occupied by a SATA-type M.2 device, SATA3_0 will be disabled.
* If M2_2 is occupied by a SATA-type M.2 device, SATA3_1 will be disabled.
* If M2_3 is occupied by a SATA-type M.2 device, SATA3_4 and SATA3_5 will be
disabled.
* If M2_3 is occupied by a PCIe-type M.2 device, SATA3_4, SATA3_5, SATA3_6 and
SATA3_7 will be disabled.
* If PCIE4 slot is occupied, M2_2 slot will support M.2 PCI Express module up to Gen3 x2
(16 Gb/s).
Installing the M.2_SSD (NGFF) Module
The following is an example of installing M.2_SSD (NGFF) module into the M2_2.
E D
No.
Nut Location
PCB Length
Module Type
30
5
4
3
2
1
C B A
1
A
3cm 4.2cm
Type2230 Type 2242
Step 1
Prepare a M.2_SSD (NGFF) module
and the screw.
Step 2
Depending on the PCB type and
length of your M.2_SSD (NGFF)
module, find the corresponding nut
location to be used.
2 3
B C
6cm
Type2260 Type 2280
4 5
D E
8cm 11cm
Type 22110