Troubleshooting - WOLFF 2 LP Original Bedienungsanleitung

5.5

Troubleshooting

Fault found
The cleaner fails to start
Dust is leaking out
The vacuum cleaner does not work as it
should
Motor very noisy.
Warning!
For any other problems, contact the UZIN UTZ TOOLS GMBH & CO. KG after-sales service
Possible fault
No power
Thermal magnetic switch
tripped
Perforated vacuum pipe
Perforated filter
Filter unsuitable for type of job
Pipe perforated or blocked
Bag full
Filter blocked
Seals worn
Air leak
Contact UZIN UTZ TOOLS GMBH & CO. KG after-sales
Recommended remedy
Check the power mains supply
Check the integrity of the plug
and power cable
Reset the thermal magnetic
switch
Replace the pipe
Replace the filter
Fit a suitable filter for the type
of material to be vacuumed
Check the pipe and, if
necessary, replace it
Empty bag
Clean the filter and if necessary
change it.
Check the seals and, if
necessary, replace it
Check for any air leaks out of
closing fasteners, tightening
screws, Longopac® container or
filter chamber