Removal And Placing Of The Waste Bag - WOLFF 2 LP Original Bedienungsanleitung

4.3

Removal and placing of the waste bag

Stop the vacuum motors by pressing the relevant STOP buttons.
Warning!
Disconnect the plug from the power socket.
Use two clamps to fasten the collection bag at two points (about 3 – 5 cm. from each other), just below
the filter chamber.
Cut off the bag in the position between the two clamps.
Remove the lower part of the bag.
Pull down a length of new bag from the chamber, until it reaches the bottom support plate
Attention!
Used bags should be disposed of into a special waste disposal container, in accordance with laws
applicable in the country where the vacuum cleaner is used.
Uzin Utz Tools GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-10
E-Mail tools@uzin-utz.com | Internet www.wolff-tools.de
- - 21 -