Operating Instructions - T4W PIK GUN CLASSIC Bedienungsanleitung & Ersatzteilliste

Operating instructions:

1. remove loose soiling from the surface you wish to clean (brush or vacuum clean)
2. Turn the green rocker lever into the vertical position to activate the (cleaning) liquid in the
bottle.
3. Important: Hołd the cleaning spout at a distance of only 1-3 cm from the surface you are
cleaning.
4. Press the "trigger" all the way; move the classic PIk cleaning gun slowly with circular
motions over the surface you are cleaning.
5. Turn the green rocker lever into the horizontal "air only" position, press the trigger and dry the
surface you have cleaned.
6. To remove any remaining moisture, wipe the cleaned surface with a dry cloth.
7. clean the spout as follows: Turn the green control switch to the horizontal "air only" position,
hołd the cleaning nozzle in a bucket and press the trigger all the way in order to remove any
soiling from the nozzle.
CARE AND MAINTENANCE
clean the classic PIk cleaning gun after each usage as described in point 7.
REQUIRED AIR RATE
To perform to its full potential, the classic PIk cleaning gun requires a constant air pressure of max.
6.2 bar.
Constant
depending on the size and power
of the compressor. Always make
sure that the tank and the air
hoses are free from impurities of
Downloaded from www.Manualslib.com
PIK
air rates
any kind.
manuals search engine
GUN CLASSIC
q
vary
8
Thoma • Tel./Fax: +48 95 741 11 62 • info@t4w.eu • www.t4w.eu
with brush