Operating Instructions; Care And Maintenance After Use - T4W PIK SUPER BLACK Bedienungsanleitung

Operating Instructions

1. Remove loose dirt from the surface you
wish to clean (brush or vacuum clean)
2. Turn the green liquid on-off switch
into the vertical position to start using
the (cleaning) liquid in the bottle.
3. Important: For best results, hołd the
cleaning spout at a distance of 1-3 cm from
the surface you are cleaning and preferably
at an angle of approx. 90° from the surface.
4. Press the "trigger" all the way; move the
cleaning gun slowly in circular motions
over the surface you are cleaning.
5. Turn the green switch into the horizontal
"air only" position, press the trigger and
dry the surface you have cleaned.
6. To remove any remaining moisture, wipe
the cleaned surface with a dry cloth.
7. To adjust the speed, rotate the
cone as indicated by the Hi-
Lo markings on the nozzle.
Constant air rates vary depending on the size and power of the
compressor. Always make sure that the tank and the air hoses
PIK GUN SUPER BLACK
q
Care and maintenance
after use
•
•
•
•
Required air rate:
To perform as its full potential, the Super
Black Booster requires a constant air pressure
between 5.0 and 8.0 bar.
are free from impurities of any kind.
8
Thoma • Tel./Fax: +48 95 741 11 62 • info@t4w.eu • www.t4w.eu
Clean the spout as follows: Turn the green
switch to the horizontal "air only" position,
hołd the cleaning nozzle in a bucket and
press the trigger all the way in order to
remove any soiling from the nozzle.
Replace damaged parts immediately for
your own safety. The rotating-set, nozzle,
hoses and gaskets are consumable parts.
In addition, you need to flush the hoses
and the suction filter after every use.
Always shut off air supply, drain hose of air
pressure and disconnect the tool from the
air supply, when not in use, before changing
accessories or when making repairs.