Operating Instructions; Care And Maintenance After Use - T4W PIK BLACK Bedienungsanleitung & Ersatzteilliste

Operating Instructions

1. Remove loose dirt from the surface you
wish to clean (brush or vacuum clean)
2. Turn the green rocker lever into
the vertical position to activate the
(cleaning) liquid in the bottle.
3. Important: Hold the cleaning spout
at a distance of only 1-3 cm from
the surface you are cleaning and
at an angle of approx. 45°.
4. Press the "trigger" all the way; move the
cleaning gun slowly in circular motions
over the surface you are cleaning.
5. Turn the green rocker lever into
the horizontal "air only" position,
press the trigger and dry the
surface you have cleaned.
6. To remove any remaining moisture, wipe
the cleaned surface with a dry cloth.
Constant air
depending on the size and
power of the compressor.
Always make sure that the
tank and the air hoses are free
from impurities of any kind.
PIK GUN BLACK
q
Required air rate: To perform as its full
potential, the Black PIK requires a constant air
pressure max. 6.5 bar
rates vary
8
Thoma • Tel./Fax: +48 95 741 11 62 • info@t4w.eu • www.t4w.eu
Care and maintenance
after use
• Clean the spout as follows: Turn the green
switch to the horizontal "air only" position,
hold the cleaning nozzle in a bucket and
press the trigger all the way in order to
remove any soiling from the nozzle.
• Replace damaged parts immediately for
your own safety. The rotating-set, nozzle,
hoses and gaskets are consumable parts.
• In addition, you need to flush the hoses
and the suction filter after every use.
• Always shut off air supply, drain hose of air
pressure and disconnect the tool from the
air supply, when not in use, before changing
accessories or when making repairs.