Modster VECTOR 80 Betriebsanleitung Seite 16

Manual
Binding process of remote control and receiver:
The remote control should already be bound to the receiver by
delivery. If needed you can always redo the binding as follows:
• Transmitter and receiver controller unit must be switched off
• Switch on the receiver controller
• Switch on the transmitter within 5 seconds
• The LED on the receiver will now blink for 3-8 seconds
• When this LED stops blinking, the binding was successful
1. Insert 4 pieces mignon AA batteries* into the
transmitter and check polarity!
* not included
To drive forwards slowly, pull the throttle lever gently. Accellerate by
pulling the lever further to you. Let the lever go to create a standstill.
Move the steering wheel clockwise to drive right. Move the wheel
counter clockwise to drive left.
16
Pull switch up:
ON
Pull switch down:
OFF
MODSTER VECTOR 80
Antenna
LED indicator
LED steady light:
Battery ok
LED flashing:
Low battery
www.modster.at