Rudder Installation - Modster VECTOR 80 Betriebsanleitung

Manual
5. Contents
6. Transmitter
Status-LED

Rudder installation

www.modster.at
Trimmer Steering
Dual Rate
On/Off
Steering-Reverse
1. Assembled Boat
2. Radio Transmitter
3. Bind Plug (brushless version only)
4. Hexagon driver
5. Display Stand
Steering
Throttle
Throttle-Reverse
1. Align the propeller along the flex shaft, then fix it
with the locknut onto the shaft.
2. Install the rudder horn to the rudder with two
screws.
3. Install the rudder to the rudder holder and fix it by a
bolt as shown in the image.
4. Connect the cooling line to the fitting on the top of
the rudder.
5. Ensure the trim tab panel is either perpendicular
to or parallel to the bottom of the boat. If it's needed,
change the angle of the panel by tying or releasing the
according screw.
MODSTER VECTOR 80
15