Samsung HW-K950 Bedienungsanleitung Seite 21

2. Turn off the Soundbar.
3. Press and hold the VOL button on the remote control for at least 5 seconds with the Soundbar turned off (off).
4. The ID SeT message appears on the display of the Soundbar for a short period of time, and then disappears.
5. When the blue indicators on the subwoofer and surround sound speakers blink, turn on the power by pressing
button on the right side of the main unit or on the remote control.
6. When the connection is successfully established, the blue indicators on the rear of the subwoofer and surround
speakers turn on without blinking.
● If the connection process fails, the blue indicators will flash continuously. Go to Step 1 and start again.
LeD inDiCatOr LaMP StatUS On SUBWOOfer anD
SUrrOUnD SOUnD SPeaKerS
LeD Status
red
Blue
Blinking
red and blue Blinking
iD Set
Description
Standby (with the Soundbar main
unit turned off)
on
Connection failed
Successfully connected
on
(normal operation)
Standby (with the Soundbar main
unit turned off)
Connection failed
malfunction
Check the power supply to the
(refer to the instructions on manual
connection in the user manual)
Check the power supply to the
(refer to the instructions on manual
connection in the user manual)
21
CONNECTIONS
right Side of the Soundbar
resolution
Soundbar main unit
Connect again
-
Soundbar main unit
Connect again
Contact the service centre.