Specific Safety Rules - Makita 8406c Betriebsanleitung

ENGLISH
1 Grip base
2 Side grip
3 Teeth
4 Cover
5 Chuck key
6 Depth gauge
7 Clamp screw
8 Lock button
9 Trigger switch
10 Speed change lever
11 Handle
SPECIFICATIONS
Model
Capacities
Concrete
DIamond core bit ........................................... 152 mm
Tungsten-carbide tipped bit ............................. 20 mm
Steel ................................................................... 13 mm
Wood .................................................................. 30 mm
–1
No load speed (min )
High ......................................................... 1,800 – 4,000
Low............................................................. 900 – 2,000
Blows per minute
High ..................................................... 28,800 – 64,000
Low...................................................... 14,400 – 32,000
Overall length ......................................................455 mm
Net weight ..............................................................4.5 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed Safety
instructions.
4
Explanation of general view
12 Speed adjusting dial
13 Action mode change lever
14 Rivet
15 Sponge
16 Diamond core bit
17 Guide ring
18 Adhesive sheet
19 Pilot groove
20 Core material
21 Holder
22 Hex wrench
8406C
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to hammer drill safety rules. If you use this power
tool unsafely or incorrectly, you can suffer serious
personal injury.
1.
2.
3.
4.
5.
6.
7.
8.
9.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
23 Screw
24 Marking
25 Center bit
26 Core bit
27 Bit shank
28 Center of hole
29 Small rod
30 Limit mark
31 Brush holder cap
32 Screwdriver

SPECIFIC SAFETY RULES

Wear ear protectors with impact drills. Exposure
to noise can cause hearing loss.
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
Hold the tool firmly with both hands.
Keep hands away from rotating parts.
Do not leave the tool running. Operate the tool
only when hand-held.
Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
GEB003-2