Schüco MPE 230 PG03 Modulmontage Seite 19

6. Mounting Schüco Modules
A suitable installation system must be used to ensure that the modules are fixed in position such that there are no
fatal injuries or damage to people or property.
The module will be installed using a clamp in the areas described on the long frame side (±40 mm /±1½")
maximum permissible load-bearing capacity also then applies for this type of fixing.
Instructions (e.g. retaining clips) are available in the installation and operating instructions for the „Schüco MSE
210 system".
The mounting rails used must be designed to support expected snow and wind loads. The wind and snow loads
expected of the module may not exceed the permitted load-bearing capacity of the module.
Depending on the type and construction of mounting rails, the modules must be rear-ventilated sufficiently to avoid
a drop in yield or structural damage.
IMPORTANT
A fireproof barrier has to be used under the modules.
portrait
retaining clips
04.2012
L/4
L/4
L
L/4
L
L/4
landscape
274 116
L
L/4
L/4
L/4
L
EN
.The
L/4
19