Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
Connect the mains cable to a properly installed
and earthed wall outlet.
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply first.
NOTE:
Ask another person to assist.
You possibly need:
driver as well as a thin-blade screwdriver.
*Delivery scope!
Keep the parts to be replaced for another possible
door stop change.
screw wrench, Phillips screw-
Remove the hinge cover and dismount the upper
door hinge.
Lift out the freezer door; move the door stopper
on the door underside. Set the door safely aside.
Dismount the middle door hinge. Lift out the fridge
door; move the door stopper on the door undersi-
de. Set the door safely aside.
Tilt the unit slightly backwards and block it in this
position. Unscrew the feet and disassemble the
lower door hinge.
Transfer and fasten the lower door hinge to the
opposite device side. Screw in the feet accordin-
gly.
Put the device back in the upright position. Move
the blind plugs to the exposed holes of the middle
door hinge.
Put on the fridge door and fix it in the intended
position.
Rotate the middle door hinge by 180°, move and
fasten it on the opposite device side.
Move the dummy cap on the device top into the
opposite exposed holes.
Put on the freezer door and fix it in the intended
position.
Transfer and fasten the upper door hinge to the
opposite device side; after you have unscrewed
the hinge pin and inserted it from the other hinge
side.
Put on the hinge cover* included in the scope of
delivery.
20