Troubleshooting - Ariete TWIN AQUAPOWER 4241 Handbuch

PROBLEM
General (for all functions)
The appliance will not start
Vacuum cleaner (dry suction)
Dust is dispersed while it is being cleaned
up.
Suction power is slowly weakening or is
inadequate
Wet and dry cleaning
Suction power suddenly drops
There is persistent and abnormal forma-
tion of foam in the dirty water container
No detergent is coming out although the
pump is on.

TROUBLESHOOTING...

POSSIBLE REMEDY
Make sure that the appliance is correctly plugged in and that the indicator
lights are off.
If the failure continues, contact an authorised repair service.
Make sure that the container and filter are correctly fitted.
Make sure that there is enough water in the container for dirty water.
VMake sure that the hose connector and/or attachments are not clogged
with dirt.
If they are, remove and clean them or rinse them with water.
Make sure that the motor filter or "Magic filter" are not dirty or incorrectly fitted.
Make sure that the "Magic filter" and motor filters are not clogged and clean
them if necessary.
Check to make sure that the openings, suction hose or suction manifold are
not clogged with dirt.
If this is the case, move the hose during cleaning to free it of dirt and dust.
Adjust the power using the special dial.
Make sure that the mechanical suction control on the handgrip is closed and
if not, close the tab on the handgrip.
Make sure that the dirty water container isn't full. If this is not the case, empty
and clean it.
Make sure to use original Ariete or a recommended detergent. Replace if
necessary.
Make sure that there is enough detergent inside the water and detergent
container (T) and be sure to fill it if necessary.
Make sure that the spray nozzle is not clogged. If this is not the case, rinse it
under running water, being careful of the parts it contains.
If the problem persists after refilling with detergent or after cleaning, then
repeat the steps for first-time use.
- 17 -
EN
I T