Attachments - Ariete TWIN AQUAPOWER 4241 Handbuch

• As soon as the light switches on to show there is no water (M), it is necessary – if needed – to refill the water and deter-
gent container (T). Switch off the appliance and unplug it from the mains electricity and, after removing the cap (R), fill
with water or a mix of water and detergent, following the doses stated above.
• If the suction power should diminish during use, this means that dirt needs to be removed from the container (E) or that it
is necessary to check the valve on the hand grip ③, or the power adjustment dial (Q).
• When you have finished cleaning, switch off the appliance by pressing the on/off switch for the suction function (L) and
then press the relevant switches to stop the water dispensing function.
• Unplug the appliance from the mains power and rewind the power cord automatically inside the appliance by pressing
the button (P) with your foot (
• The appliance can be stored using the special hook for the floor brush (
CAUTION: When the appliance light (O), switches on, the motor will switch off automatically; after emptying
the container (E) , press the on/off switch (L) to start the appliance again.
Rigid suction tubes ⑬
Especially useful for reaching high or hidden areas (below furniture units, sofas, beds, etc.). These tubes can be fitted directly
to the hand grip ①.
Floor brush ⑧ and parquet floor attachmenT ⑨
Ideal for cleaning hard surfaces such as floors or walls. A joint allows the brush to rotate through 360° to clean in all areas
that are difficult to reach. It can be fitted directly to the hand grip ① or tube ⑬. The parquet floor attachment ⑨ fits to the
brush ⑧ and is used for thorough parquet cleaning (
"Magic Brush" ⑭ liquid vacuum brush and rubber scraper ⑮
Ideal for cleaning up liquids on hard surfaces such as floors as well as on rugs and carpets. It guarantees perfect suction of
liquids to leave surfaces perfectly dry and it can be used for dry vacuum cleaning with excellent results.
Use it with the rubber scraper on hard surfaces and without the scraper on rugs and carpets (
To fit this attachment, push it in backwards or forwards so that the rubber scraper slides in easily.
When this attachment is used with the detergent dispenser, it is first necessary to fit the spray ⑥ to clean rugs and carpets
so as to apply detergent evenly over the surface to be cleaned. It can be fitted to the hand grip ① or tube ⑬.
WARNING: If the brush sticks to the floor during operation, it is sufficient to open the valve on the handgrip.
"Magic Turbo Brush" ⑰ - for Mod. 4241/1 - 4242/1 only
A special turbo brush capable of removing dirt deep down, using a roller with bristles. During the suction function, the dirt and
dust on carpets, rugs and floors will be vacuumed up effortlessly. This is the ideal brush for people with pets and in fact, the
special turbo brush removes hair and fluff to leave surfaces perfectly clean.
Crevice nozzle ⑦
Ideal for special cleaning operations (crevices between furniture units, seats and chairs or sofas) where suction cleaning is
difficult. It can be fitted to the hand grip ① or tube ⑬ (
Fabric cleaning nozzle ⑩ and bristled attachment ⑪
This is particularly suited for cleaning surfaces such as armchairs, rugs, and smaller-sized hard surfaces, and also for fabrics
and curtains. It can be fitted to the hand grip ① or tube ⑬. The bristled attachment ⑪ can be fitted to the nozzle ⑩; and it
is recommended for cleaning small-sized fabric surfaces (
Kit for cleaning glass and windows ⑫
Ideal for large glass surfaces, large mirrors, and smooth surfaces in general. It can be fitted to the hand grip ① or tube ⑬.
To use the glass washer correctly, proceed as follows:
• Evenly dispense the detergent over the surface to be cleaned so as to dissolve the dirt.
• Press the rubber scraper over the surface to be cleaned, moving it in vertical strokes from top to bottom, with the suction
function on.
).
10

ATTACHMENTS

).
12
14
15
- 15 -
).
11
).
).
EN
I T
).
13