Lightmaxx LED BAR 8 SECTOR Bedienungsanleitung Seite 20

ENGLISH
Commissioning:
All connections of the device should be made before switching on. Only use high-quality cables
that are as short as possible for the connections.
Configuration of the DMX connector:
Resistance 120 ohm 1/4w between pin 2 (DMX-) and pin 3 (DMX+) of the last fixture.
Operating mode DMX:
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX chain. Always use a DMX cable
with a 110 Ohm resistor for this connection. Address the device according to your DMX
configuration. The device has a DMX mode with 2, 3, 4, 7, 14 or 26 channels, which are based
on the following functions: