Lightmaxx LED BAR 8 SECTOR Bedienungsanleitung Seite 19

Installation:
Be sure to check the unit for damage before using it. Optimally, use the original packaging or
suitable transport or storage packaging to protect the product from dust, moisture, etc. when
not in use.
The unit can be installed upright or suspended. The device must always be attached to a solid,
approved carrier or a suitable surface. The opening in the product bracket must be used to
fasten the device. Always provide a second, independent safety device for the device, e.g. a
safety device.
Work on the device (e.g. assembly) should always be carried out from a stable and permissible
platform. Make sure that the area below you is closed off.
Please note that it is not possible to use this device with a dimmer!
WARNING! (Risk of injury due to falling down)
It must be ensured that the installation of the device complies with all legal standards
and regulations in the respective country of use. It must be ensured that the device is
always secured by a second fastening (e.g. Safety).
NOTE! (Risk of overheating)
The max. permissible ambient temperature of this device is 40° C.
Make sure that the device is always adequately ventilated.
NOTE! (Using tripods)
As soon as the unit is mounted on a tripod, it must always be ensured that it stands
securely and securely. Make sure that the maximum permissible load capacity of your
tripods is not exceeded.
NOTE! (Error during data transmission)
Never connect the DMX input or output to audio devices such as power amplifiers or
mixers!
DMX cables enable trouble-free operation and the highest possible transmission
reliability of signal data. Do not use microphone cables.
ENGLISH