CLIVET BOX 2 950x950 Handbuch Für Installation, Bedienung Und Wartung Seite 62

3 Install the panel
– Align the front panel with the main body, taking
into account the position of the pipes and the drain
side.
– Attach the four decorative panel rings to the indoor
unit hooks.
– Tighten the screws of the panel hooks in the four
corners equally.
m
CAUTION
Tighten the screws until the thickness of the
spongy material between the main body and
the panel is down to 4-6 mm. The edge of the
panel must fully touch the ceiling.
Drain side
Lower motor
Screwdriver
Main body
Ceiling
Sponge
Panel
Air outlet
Foam
– Adjust the panel by turning it to completely cover
the opening in the ceiling.
22
Pipe side
Foam
Air inlet
Foam
Baffle
Fig. 30
– Connect the two connectors of the ventilation slit
motor to the corresponding cables in the electrical
panel.
Install cover rope
Panel hook
– Reinstall into the grid.
– Reinstall the installation cover.
– Install the cover plate rope to the hook and gently
press the cover plate into the panel.
m
CAUTION
After installation, the connectors of display,
swing, water pump and other cables must be
placed in the electrical panel.
Installation
Bolt
Fig. 31
When installing the
cover, slide the four
slide fasteners into
the corresponding
slots on the panel.
Fig. 32