Cleaning And Maintenance - BOMANN VS 2195 Bedienungsanleitung, Garantie

• Leave open the appliance door to avoid formation
of mold and unpleased odor.
Tips for Energy saving Tips for Energy saving Tips for Energy saving Tips for Energy saving
• Disconnect the appliance from the power supply,
if it isn't in use.
• Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
• Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
• Adjust the temperature not colder than necessary.
• Allow warm food to cool before placing it in the
appliance.
• Open the unit door only as necessary.
• Defrost the unit regularly (model dependent).
• The seal of the appliance door must be complete-
ly intact, so that the door closes properly.

Cleaning and Maintenance

Cleaning and Maintenance
Cleaning Cleaning and Maintenance and Maintenance
WARNING: WARNING:
WARNING: WARNING:
• Always disconnect the appliance from the power
supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage Risk of electric shock! Risk of electric shock! Risk of electric shock!
the plastic parts.
• The unit must be dry before restarting operation.
CAUTION: CAUTION: CAUTION: CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior Cleaning the appliance including interior
Cleaning the appliance including interior Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
All manuals and user guides at all-guides.com
• Remove the appliance content and storage it at a
• Clean the thaw water discharge channel / opening
• After everything was thoroughly dried, you can
Defrosting Defrosting
Defrosting Defrosting
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
Changing the bulb Changing the bulb Changing the bulb Changing the bulb
Do NOT
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.
20
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
cool location.
carefully e.g. with a pipe cleaner.
restart the operation.
CAUTION: CAUTION: CAUTION: CAUTION:
CAUTION: CAUTION: CAUTION: CAUTION:
NOT remove the cover of the interior light.
NOT NOT