Makita DFL061F Bedienungsanleitung Seite 8

6. Align the yellow line with your desired number on
the fastening torque scale.
7. Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
8. Rotate the ring in front of the tool and then tighten
the screw to secure the ring.
NOTE:
• Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket or screw bit
There are different types of sockets or bits for some
models depending on applications. Choose and install a
correct socket or bit for your application.
Installing or removing socket
► Fig.8: 1. Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
Installing or removing bit
► Fig.9: 1. Screw bit 2. Sleeve
For tools with retracting sleeve
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
For tools without retracting sleeve
To install the bit, just insert the bit into the spindle as far
as it will go. To remove the bit, pull the bit out firmly.
All manuals and user guides at all-guides.com
OPERATION
Hold the tool firmly and place the socket over the bolt
or nut. Then switch the tool on. When the clutch cuts
in, the motor will stop automatically. Then release the
switch trigger.
Limits of fastening capacity
Use the tool within the range of the revolution angle up
to 360°. If you use the tool beyond the upper limit of this
range, the clutch does not work. And the tool cannot
deliver enough fastening torque (LED flickers in red and
green alternatively).
MAINTENANCE
Replacing carbon brushes
► Fig.10: 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
► Fig.11: 1. Screwdriver 2. Brush holder cap
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
8 ENGLISH
NOTE:
• Hold the tool with its square drive pointed
straight at the bolt or nut, or the bolt or nut will
be damaged.
NOTE:
• The revolution angle means the angle which
a screw/bolt revolves when the tool attains to
100% from 50% of desired torque.
• Use of a low temperature conditioned battery
cartridge may sometimes give warning for
battery cartridge capacity by warning lamp and
beeper which makes the tool stop immediately.
In this case, the fastening capacity may be
inferior to the specification on this manual even
if a charged battery cartridge is used.
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.