Makita DFL061F Bedienungsanleitung Seite 7

LED indicator / Beeper
LED indicator / Beeper on the tool shows the following functions.
Function
This function works when the tool has reached
the preset fastening torque and normal
Auto-stop fastening
tightening has been completed. This helps
overtightening to be avoided.
For approximately one second after auto-stop
Delayed re-start fastening, the tool does not start even if the
switch trigger is pulled.
Insufficient fastening has been performed
Warning against
when the switch trigger has released before
insufficient fastening
reaching the preset fastening torque.
This indicates the appropriate time to replace
Warning for battery
the battery cartridge when the battery power
cartridge capacity
becomes low.
Checking the This function works when the battery power
remaining battery is almost used up. At this time, tool stops
capacity, Autostop immediately.
This function works to check the proper
Check the LED
operation of the LED indicator, lamp and
indicator, lamp and
beeper when a battery cartridge has been
beeper operation
inserted into the tool.
This function works when an abnormal drop
Anti-reset of
of the battery voltage occurs for some reason,
controller
and the tool stops.
This function works when the temperature
Overheat of the controller goes up very highly,
and the tool stops.
This function works to avoid the tool's
Operation error of immediate start upon insertion of battery
the switch trigger cartridge into the tool with the switch trigger
being pulled.
The tool automatically stops without the clutch
Warning for limit of
working when exceeding the fastening capacity
the fastening
limit.
capacity
Adjusting the fastening torque
► Fig.6: 1. Adjust grip 2. Ring
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Loosen the screws securing the lamp cover.
3. Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
All manuals and user guides at all-guides.com
Status
Lights up in green for
approximately one
second.
Lights up in red.
Flickers in red slowly.
Lights up in red.
Lights up first in green,
next red.
(And then the lamp
comes on.)
Flickers in red and
green alternatively.
Flickers in red quickly.
Flickers in red and
green alternatively.
Flickers in red and
green alternatively.
4.
► Fig.7: 1. Angle head 2. Adjust ring 3. Ring 4. Scale
5.
7 ENGLISH
Status of the LED indicator/beeper
LED indicator Beeper
-
A long beep
A series of long
beeps
A long beep
A series of very
short beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjust ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
5. Adjust grip 6. Hole for adjust grip 7. Yellow
line 8. Compression spring
Use an optional adjust grip to adjust the fastening
torque. Insert the pin of the adjust grip into the
hole in the front of the tool. And then, turn the
adjust grip clockwise to set a greater fastening
torque, and counterclockwise to set a smaller
fastening torque.
Action to be taken
-
Retighten the
screw.
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
-
Replace the battery
with fully charged
one.
Remove the battery
cartridge immediately
and cool the tool
down.
Release the switch
trigger.
Remove the battery
cartridge and then
install it again.
Be sure to use the
tool under load within
its capacity.