Installation Location; Outline Dimensions (Outdoor Unit); Installing The Indoor Unit - Mitsubishi Electric Mr.SLIM PCA-RP KAQ Serie Installationshandbuch

2. Installation location

3. Installing the indoor unit

2
75
233
246
Downloaded from www.Manualslib.com
Fig. 2-1
Fig. 3-1
A
2
B
85 86 2
138
C
D
233
246
Fig. 3-2
manuals search engine
2.1. Outline dimensions (Indoor unit) (Fig. 2-1)
(mm)
Select a proper position allowing the following clearances for installation and main-
tenance.
Models
RP50
RP60,71
RP100 ,125,140
Warning:
Mount the indoor unit on a ceiling strong enough to withstand the weight of
the unit.

2.2. Outline dimensions (Outdoor unit)

Refer to the outdoor unit installation manual.
3.1. Check the indoor unit accessories (Fig. 3-1)
The indoor unit should be supplied with the following accessories
(contained in the inside of the intake grille).
Accessory name
Washer
Pipe cover
Pipe cover
Band
Joint socket
Socket cover
Drain tubing cover
Flare nut
3.2. Preparation for installation (Fig. 3-2)
(mm)
236
3.2.1. Suspension bolt installing spacing
Models
RP50
RP60,71
RP100,125 ,140
3.2.2. Refrigerant and drain tubing location
Models
RP50
RP60
RP71-140
Front side outlet
Left side outlet
Right side outlet
Independent piece (Removable)
Right drain tubing
In case of the rear pipe arrangement, make sure to remove the shaded portions
from the independent piece. Then put the
position.
(The heat exchanger might be clogged because of dust)
W
960
1280
1600
Q'ty
4 pcs
1 pc Large size (For gas tubing)
1 pc Small size (For liquid tubing)
4 pcs
1 pc Marked with "UNIT"
1 pc
1 pc
1 pc ø6.35 (RP60 only)
(mm)
A B
917 960
1237 1280
1557 1600
(mm)
C D
184 203
179 203
180 200
Left drain tubing
Gas tubing
Liquid tubing
Rubber plug
with Joint socket
independent piece back in initial
3