Installing/Removing Main Memory - Siemens Fujitsu D2764 Kurzbeschreibung

Brief description of mainboard

Installing/removing main memory

Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "www.fujitsu-siemens.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
Slot to be used
Channel A, Slot 1
Channel B, Slot 2
Channel A, Slot 3
Channel B, Slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
4 - English
Downloaded from www.Manualslib.com
DDR2 667 / 800 unbuffered DIMM modules 240-Pin; 1.8V; 64 Bit, no
ECC
128 Mbytes to 8 Gbyte DDR2
128, 256, 512, 1024 or 2048 MByte for one socket
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2-memory modules must meet the PC2-5300U or PC2-6400U specification.
If you use more than one memory module, make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieved when the same memory size
is used in Channel A and Channel B.
To simplify equipping, the slots are colour coded. When inserting the memory
modules, start with the slot furthest away from the processor (slot 4).
To simplify equipping, the slots are colour coded.
With a memory configuration of 8 Gbytes the visible and usable main memory can
be reduced down to 7 Gbytes (depending on the system configuration).
slot 4
slot 3
manuals search engine
Channel B
Channel A
Number of memory modules inserted
1 2
x x
x
A26361-D2764-Z110-1-7419, edition 1
slot 2
slot 1
3 4
x x
x x
x x
x