Installing/Removing Main Memory; Pci Bus Interrupts - Selecting Correct Pci Slot - Siemens Fujitsu D2750 Kurzbeschreibung

Brief description of mainboard

Installing/removing main memory

Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "www.fujitsu-siemens.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
The installation/removal is described in the "Basic information on mainboard" manual.

PCI bus interrupts - Selecting correct PCI slot

Extensive information on this section is contained in the manual "Basic information on mainboard".
Which ISA IRQs are assigned to the PCI IRQ Lines is normally automatically
specified by the BIOS (see "BIOS Setup" description).
Monofunctional expansion cards
PCI/PCI Express expansion cards require a maximum of one interrupt, which is called the PCI
interrupt INT A. Expansion cards that do not require an interrupt can be installed in any desired slot.
4 - English
Downloaded from www.Manualslib.com
DDR2 667 / DDR2 800 unbuffered DIMM modules 240 pin; 1.8V;
64 Bit, no ECC
256 MBytes to 4 GBytes
256, 512, 1024 or 2048 Mbytes per module
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2-memory modules must meet the PC2-5300U or PC2-6400U specification.
With a memory configuration of 4 GB the visible and usable main memory can
be reduced to 3 GB (depending on the system configuration).
To achieve optimum stability, performance and compatibility, avoid the multiple use
of ISA IRQs or PCI IRQ Lines (IRQ sharing). Should IRQ sharing be unavoidable,
then all involved devices and their drivers must support IRQ sharing.
manuals search engine
A26361-D2750-Z110-1-7419, edition 2