Operation; Cleaning / Maintenance; Cleaning & Maintenance - Lacor 69283 Gebrauchs- Und Instandhaltungsanleitung

1.- Cut the fruit in half.
2.- Place a jar or recipient under the tap of the juice container.
3.- Connect the power cable to an electricity outlet of 220-240 V/50Hz.
4.- Press the ON/OFF switch to switch on the juicer and place the central part of the fruit on the
centre of the cone.
5.- Move the lever downwards, so the pressing cone presses the fruit towards the cone and the
motor starts to turn.
6.- The juice will fall directly into the jug that we have previously positioned.
7.- Raise the lever, remove the peel and carry out the same operation until obtaining the desired
quantity of juice.
NOTE: We recommend cleaning the pulp left in the filter, every 15-20 operations.
8.- Once again press the ON/OFF switch to switch the juicer off.
NOTE: If during the juicing process, the sound of the motor slows, the force of the pressure
exercised on the cone is higher than necessary. The motor can overheat and the juicer will
switch off for safety. Let it cool for a few minutes before using it again.
1.- Before cleaning the device, make sure it is disconnected.
2.- Do not use chlorine products or bleaches, this can permanently damage the stainless steel
surfaces, Use a damp cloth or duster and make sure of thoroughly drying it.
3.- Rinsing the main body of the device with water is prohibited. Use a damp cloth to clean it.
4.- Remove all the accessories from the juicer to facilitate its cleaning. Make sure correctly drying
them before re-assembling them.
5.- For long periods of not being used, store the juicer should be stored in a dry place, to avoid
humidity in the motor.
18

OPERATION

CLEANING / MAINTENANCE