Control; Child Proofing; Refrigerator Compartment - Atag KD80102ADN Gebrauchsanweisung

5 Control

5.1 Child proofing

The child-proofing function enables you to make
sure that the appliance is not inadvertently switched
off by playing children.
5.1.1 Setting the child lock
To activate the setting mode:
u Press the Fast Cool button
w The Menu symbol is shown on the display,
flashes on the display.
w c
To switch on the function:
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
appears on the display.
w c1
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
Fig. 2 (9) , lights up on the
w The child lock symbol,
display.
flashes on the display.
w c
w The child lock function is switched on.
If the function is to be switched off:
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
appears on the display.
w c0
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
flashes in the display.
w c
w The child lock function is switched off.
To end the setting mode:
u Briefly press the On/Off button
w The temperature display shows the temperature again.

5.2 Refrigerator compartment

The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the vegetable drawers and at the rear wall. It is warmest
at the top front of the compartment and in the door.
5.2.1 Food refrigeration
Note*
The energy consumption increases and the cooling perform-
ance decreases if the ventilation is inadequate.
u Always keep the air slits of the fan free.
u Store perishable food such as ready-to-serve dishes, meat
products and sausages in the coldest zone. Place butter and
preserves in the upper area and in the door (see Appliance
at a glance).
u Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u Always store liquids and food which is subject to odour or
taste transfer in closed containers or cover them.
u Foods which give off a large amount of ethylene gas and
delicate foods, such as fruit, vegetables, salad, should
always be stored separately or wrapped so as not to reduce
the storage life; e.g. do not store tomatoes together with
kiwis or cabbage.
for appliances from 1218 mm in height, the following applies:
u Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
* Depending on model and options
Fig. 2 (4) for approx. 5 seconds.
Fig. 2 (8) .
Fig. 2 (1) .
u Do not store food too close together to enable good air
circulation.
5.2.2 Setting the temperature
The temperature depends on the following factors:
- the frequency of opening the door
- the room temperature of the installation location
- the type, temperature and quantity of the food
Recommended temperature setting: 5 °C
The temperature can be adjusted continually. Once the 1 °C
setting is reached, the sequence starts again at 9 °C .
u Call up the temperature function: Press the "+/-"
Fig. 2 (3) .
setting button
w The previously-set value will flash in the tempera-
ture display.
u Change the temperature in 1 °C steps: Press the
Fig. 2 (3) until the required
"+/-" setting button
temperature is indicated in the temperature
display.
u Change temperature continually: hold down
setting button.
w During adjustment the value flashes on the display.
w The new setting is adopted approx. 5 seconds after the last
time the button was pressed and the set temperature
displayed again. The temperature in the interior gradually
adjusts to the new value.
5.2.3 Fast Cool
Use Fast Cool to activate the highest cooling
performance to reach lower cooling temperatures.
Fast Cool is used for rapidly cooling large amounts of
food.
The fan is in operation when Fast Cool is switched on*. The
appliance operates with the maximum cooling capacity; conse-
quently, noises emitted by the cooling unit may be temporarily
louder.
Fast Cool has a slightly higher energy consumption
To cool using Fast Cool
u Briefly press the Fast Cool button
Fig. 2 (5) illuminates in the display.
w The Fast Cool symbol
w The cooling temperature drops to the coldest value.
Fast Cool is switched on.
w Fast Cool automatically switches itself off after approx. 12 h.
The appliance continues to function in the energy-saving
normal mode.
To switch off Fast Cool ahead of time
u Briefly press the Fast Cool button
Fig. 2 (5) goes out in the display.
w The Fast Cool symbol
w Fast Cool is switched off.
5.2.4 Fan*
With the fan you can rapidly cool large quantities of
fresh food or achieve a relatively even distribution of
temperature across all the storage levels.
The forced-air cooling is to be recommended:
- at high room temperature (above33 °C )
- at high humidity
The forced-air cooling uses slightly more energy. To save
energy, the fan switches off automatically when the door is
open.
Switching on the fan*
u Briefly press the fan button
Fig. 2 (7) illuminates.
w The fan symbol
Control
Fig. 2 (4) .
Fig. 2 (4) .
Fig. 2 (6) .
19