Technical Data; Symbols And Their Meaning; Intended Use - Wolfcraft TC 710 PM Original Bedienungsanleitung

Bdal 5565.000_116305565 09.04.14 13:38 Seite 11
INTRODUCTION
• PLEASE NOTE: Read the safety and all other instructions that come with the tile cutter TC 710 PM. Failing to do so and disregarding
the safety and all other instructions may cause injuries.
• Keep these operating instructions for future reference in a safe place.

TECHNICAL DATA

Equipment dimensions:
maximum cutting length:
thickness of the material:
maximum cutting width with edge guide:
minimum cutting width:
weight:

SYMBOLS AND THEIR MEANING

Warning - general danger
Read the instructions!
For general information

INTENDED USE

The tile cutter is suitable for cutting glazed, enamelled and ceramic tiles, as well as stoneware and split tiles with a material thickness
of 3 - 14 mm. Maximum cutting length 710 mm. Depending on the type of tiles and their thickness, a minimum cutting width of 30 mm
with stop and 15 mm without stop is possible.
Repeat cuts with stop can be achieved with a cutting width of min. 50 to max. 300 mm. Free diagonal cuts are also possible.
Ideally, the tile should be broken as close as possible to its end. For this purpose, the cutting edge must rest fully on the tile.
To break the tile, position it on the breaking point or on the continuous breaking edge. Make sure that the spring-loaded bearing surfaces
can move freely.
Use only original cutting discs (ø 20, thickness 3 mm) and genuine cutting wheel mounts.
The user is liable for any damage or accidents resulting from improper use.
GENERAL SAFETY INSTRUCTIONS
• Always keep the working area tidy and well lit. Untidiness or unlit working areas may cause accidents.
• Keep children and other persons away from the working area when using the tool. . You may lose control over the appliance when being
distracted.
• Wear the appropriate personal protective equipment and clothing. Suitable goggles and protective gloves will prevent injuries from tile chips.
• Remove the assembly tools before using the appliance. A screwdriver left at the tool may cause injuries.
• Wear suitable clothing and no loose garments or jewelry. Keep your hair, garments and gloves away from moving parts. Loose garments,
jewelry or long hair may be caught by moving parts.
• Keep unused tools outside the reach of children. Do not allow persons using the appliance who are not familiar with it or have not read these
instructions. Cutting tools are dangerous, if being used by inexperienced persons.
• Check before starting to work, whether the equipment and tools function properly. Never work with damaged or blunt tools.
• Place the tile cutter on a solid, plain and horizontal surface. If the tile cutter can slide away or wiggle, it will be impossible to move the
cutting device smoothly and safely.
• Do not use the tile cutter as a step or a ladder. Standing on the appliance will shift its point of gravity, so that it may eventually topple over.
• Do not process any other materials but the types of tiles suggested for the appliance's intended use.
• Keep your fingers away from the cutting area; there is a danger of crushing and cutting!
• Do not remove loose chips, broken tiles or similar residues with compressed air from the appliance; they may be blown into your eyes thus
causing severe injuries. . Use a small brush to remove such residues (Fig. 12).
• Do not extend the breaking handle with a lever.
• Do not store the tile cutter outdoors. Protect against dampness: risk of corrosion.
t
928 x 250 x 120 mm (width x depth x height)
710 mm
3 - 14 mm
300 mm
50 mm (maybe more, depending on the tile conditions)
10,6 kg
Wear goggles.
Wear protective gloves.
Keep a safe distance to the cutting tool, risk of injury!
11