Manual Installation Wlan - Block AURORA Bedienungsanleitung

Manual installation WLAN

Should any problem appear while setting up the wizard, or you want to make a manual setup, please proceed
as follows:
1. Press and hold the „Mode" button on the remote control. Use the arrow buttons on the remote to select
System Settings / network / Manual Settings / Wireless.
2. In the next step, select DHCP active. This is the default setting for all common Internet routers and it takes
a lengthy network configuration. * Confirm the setting.
3. Now „OK" the name of your WLAN network (SSID), be sure to use correct spelling and case. Confirm with „OK".
4. Select the type of password protection (usually WPA2 and AES). If there is any doubt, consult the manual of
your router.
5. Now „OK" the password of your WLAN network, be sure to use the correct spelling and case. Confirm with
„OK".
6. Now the router and your Aurora should be connected and an Internet connection exists, the device will
show "Connected".
*
Should you have deactivated the DHCP function on your router, please select DHCP inactive. In this case, you must configure the network, you
should be aware of the applicable rules and information. For extended configuration, you may need the MAC address of your block device. These
can be found under Main menu / System settings / Inter- net settings / Show settings / Mac address
I
41