Safety Instructions; Precautions During Use - AEG KD91402M Gebrauchsanweisung

7 ENGLISH

2. SAFETY INSTRUCTIONS

Before connecting the appliance
compare the power data (voltage and
frequency) indicated on the
characteristics plate with those of the
power supply in question. If these data
do not match there may be problems.
In case of doubt, contact an
electrician.
If the electrical wire plug is removed,
the appliance must be installed and
connected by a technician. Contact a
qualified electrician who knows and
respects current safety standards. The
manufacturer cannot be held
responsible for damage resulting from
fitting or connecting errors.
The electrical safety of the appliance
can only be guaranteed if it is earthed.
The manufacturer cannot be held
responsible for damage resulting from
the absence of or defects in the
installation's protection system (e.g.
electrical shock).
Only use the appliance once it has
been fitted into its built-in position.
Only in this manner can it be
guaranteed that users cannot access
the electrical components.
Never open up the appliance's frame.
Possible contacts with electrical
conducting parts or changes to
electrical or mechanical components

3. PRECAUTIONS DURING USE

may represent a danger to users'
safety and prejudice the correct
working of the appliance.
Repairs and maintenance, especially
of parts carrying electrical current,
must only be done by technicians
authorised by the manufacturer. The
manufacturer and retailers do not
accept responsibility for any damaged
caused to people, animals or property
as a result of repairs and maintenance
carried out by non-authorised
personnel.
Repairs undertaken during the
guarantee period must only be done
by technicians authorised by the
manufacturer. If this is not the case
then any damage resulting from the
repair in question is excluded from the
guarantee
The appliance must be disconnected
from the electrical current when
installation and repair work is being
done. To disconnect the appliance
from the current, one of the following
conditions must apply:
The switchboard fuses / circuit
breakers must be disconnected.
The plug should be removed from
the socket. To remove the plug
from the socket do not pull on the
electric cable but rather pull out the
plug itself directly.