Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10. INSTALLATION INSTRUCTIONS
Before installation
10.1.
Check that the input voltage indicated on
the characteristics plate is the same as the
voltage of the power outlet you are going to
use.
Open the drawer and take out all the
accessories and remove the packing
material.
Attention! The front surface of the
crockery heater may be wrapped in a
protective film. Before using the crockery
warmer for the first time, remove this film
carefully.
Make sure that the crockery warmer is
not damaged in any way. Check that the
drawer opens and closes correctly. If
you find any damage, contact the
Technical Assistance Service.
Attention: the power socket should be
easily accessible after the crockery
warmer has been installed.
The crockery warmer should only be
built-in in combination with those
appliances indicated by the
manufacturer. If it is fitted in combination
with other appliances, the guarantee is
no longer valid since it is impossible to
guarantee that the crockery warmer will
work correctly.
Installation
10.2.
To build-in the crockery warmer in
combination with another appliance there
must be a fixed, interim shelf in the housing
unit to support the weight of both
appliances.
The appliance to be combined with the
crockery warmer will be placed directly on
the latter without any need to have a
separating shelf.
To build-in the appliance which is combined
with the crockery warmer, follow the
instructions set out in the respective
instructions and fitting booklet.
The relevant installation dimensions are
indicated in mm in the diagrams shown at
the end of this booklet. Proceed as follows:
1. Place the crockery warmer on the shelf
and slide it towards the interior of the
niche in such a way that it is centred and
completely lined up with the front of the
unit.
2. Check that the crockery warmer's frame
is properly levelled and is sitting evenly
on the shelf.
3. Open the drawer and fix the crockery
warmer to the sides of the unit using the
provided screws.
Electrical Connection
10.3.
Electrical installation must be performed by
an electrician qualified in accordance with
the legislation in force.
Before connecting the crockery warmer to
the electric mains, check that the voltage
and frequency of the mains matches that
which is shown on the rating plate located in
the heating block inside.
The electric connection is made via an
omnipolar switch, which is suitable for the
intensity to be tolerated and which has a
minimum gap of 3mm between its contacts,
which will ensure
disconnection in case of emergency or
when cleaning the crockery warmer.
If a plug is used for the electric connection,
then it must be accessible after installation.
www.aeg.com 14
Werbung
Inhaltsverzeichnis
