Connection technology
Connecting
VEGAMET 861 • 4 ... 20 mA/HART
5.4
Connecting
The voltage supply and inputs and outputs are connected via the
spring-loaded terminals.
Information:
Solid cores as well as flexible cores with wire end sleeves are
inserted directly into the terminal openings. In case of flexible cores
without end sleeves, a small screwdriver must be pressed into the
rectangular opening so that the terminal opening is then free. When
the screwdriver is pulled out, the terminals are closed again.
You can find further information on the max. wire cross-section in the
technical data.
Connect the device as described in the following wiring plan.
5.5
Wiring plan
Power
Relay Output
1
91 92
61 62 63 64 65 66 67 68 69 70 71 72
+
-
L
N
1
6
Fig. 6: Wiring plan VEGAMET 861
1
Voltage supply of the controller
2
Relay outputs 1 ... 4
3
Current output
4
Sensor input (active/passive)
5
Digital inputs 1/2
6
Ground terminal for protective conductor
7
Ground terminal for cable screening sensor cable
8
Ground terminal for potential equalization
5
2
3
4
2
5 Connecting to power supply
Digital IN
2122 23
24 2526
1
2
Current
Output
1
Sensor 1
41 42
1 2 3
+ -
3
4
7
8
17