Bosch PSR 300 LI Bedienungsanleitung Seite 32

OBJ_BUCH-89-004.book Page 32 Thursday, October 19, 2006 8:26 AM
Adjusting the Speed
The speed of the switched on power tool can be variably adjusted,
depending on how far the On/Off switch 9 is pressed.
Light pressure on the On/Off switch 9 results in a low rotational
speed. Further pressure on the switch results in an increase in
speed.
Battery Charge-control Indication
The battery charge-control indicator 7 consists of one green, yel-
low and red LED. Each LED indicates the charge condition of the
battery for a few seconds when the On/Off switch 9 is depressed
halfway or fully.
LED
Continuous lighting, green
Continuous lighting, yellow
Continuous lighting, red
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be subject to
overload. When the load is too high or the allowable battery tem-
perature of 70 °C is exceeded, the electronic control switches off
the power tool until the temperature is in the optimum temperature
range again.
Operating Instructions
Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Soft Grip
The gripping surface (soft grip) 5 reduces the danger of slipping
and thereby improves the grip on the machine and the handling.
At the same time, the rubber coating achieves a vibration-reducing
effect.
32 | English
Capacity
≥ 50%
30—50%
≤ 30%
2 609 001 313 • 19.10.06