Instructions For Maintenance; Reminders For The Maintenance Technician; Commissioning; Troubleshooting - ALI Proxe 70 Serie Anweisungen Für Installation, Gebrauch Und Wartung

REMINDERS FOR THE MAINTENANCE TECHNICIAN

The manufacturer will not be liable for any damage or
injury resulting from failure to observe the following
rules.
•
Read this manual carefully. It provides important
information for safe installation, use and maintenance of
the appliance.
•
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
•
Installation, conversion to a different type of gas
and appliance maintenance must be carried out by
qualified technicians authorized by the manufacturer,
in compliance with current safety standards and the
instructions given in this manual.
•
Identify the specific appliance model. The model number
is detailed on the packaging and on the appliance data
plate.
•
The appliance must be installed in a well-ventilated
room.
•
Do not obstruct any air vents or drains present on the
appliance.
•
Do not tamper with appliance components

COMMISSIONING

Following installation or any maintenance operations, check
appliance operation. In the event of any malfunction, consult
the next paragraph "Troubleshooting".
ELECTRICAL APPLIANCES
Switch on the appliance as directed in the instructions and
reminders for use given in Chapter "INSTRUCTIONS FOR
USE" and check:
•
The current values of each phase.
•
The correct operation of the heating elements.

15. TROUBLESHOOTING

ELECTRIC GRIDDLE PLATE

The appliance does not heat.
Possible causes:
•
Temperature thermostat defective.

Instructions for maintenance

•
Heating elements defective.
•
Safety thermostat tripped.
Heating cannot be adjusted.
Possible causes:
•
Temperature thermostat defective.

16. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS

•
Disconnect the appliance electrical power supply, if
present, before proceeding with any operation.
•
After replacing an electrical system component, check it
is correctly wired.
ELECTRIC GRIDDLE PLATE
Replacing the heating element and the indicator light.
•
Remove the control panel.
•
Remove and replace the component.
•
Re-assemble all parts. For assembly, proceed in reverse
order.
Replacing the working thermostat and safety
thermostat.
•
Remove the control panel.
•
Remove the bulb from its seat on the bottom of the
hotplate.
•
Remove and replace the component.
•
Insert the bulb properly in its seat on the bottom of the
hotplate.
•
Re-assemble all parts. For assembly, proceed in reverse
order.

17. CLEANING THE INTERIOR

•
Check the condition of the inside of the appliance.
•
Remove any built-up dirt.

18. MAIN COMPONENTS

ELECTRIC GRIDDLE PLATE
•
Working thermostat
•
Safety thermostat
•
Heating element
•
Indicator light.
23