Bosch pbh 2800 RE Originalbetriebsanleitung Seite 24

24 | English
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 18.
– Press the button for the depth stop adjust-
ment 15 and insert the depth stop into the
auxiliary handle 17.
The knurled surface of the depth stop 18
must face downward.
– Insert the SDS-plus drilling tool to the stop
into the SDS-plus tool holder 3. Otherwise,
the movability of the SDS-plus drilling tool
can lead to incorrect adjustment of the drill-
ing depth.
– Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drill-
ing depth X.
Selecting Drill Chucks and Tools
For hammer drilling and chiselling, SDS-plus
tools are required that are inserted in the SDS-
plus drill chuck.
For drilling without impact in wood, metal, ce-
ramic and plastic as well as for screwdriving,
tools without SDS-plus are used (e.g., drills
with cylindrical shank). For these tools, a key-
less chuck or a key type drill chuck are required.
PBH 3000-2 FRE: The SDS-plus quick change
chuck 2 can easily be replaced against the quick
change keyless chuck 1 provided.
Replacing the Drill Chuck
(PBH 2800 RE/ PBH 2900 FRE/
PBH 3000 FRE Set)
To work with drilling tools without SDS-plus
(e. g., drill bits with cylindrical shank), the key
type drill chuck or the keyless chuck must be
mounted.
Mounting the Key Type Drill Chuck
(Accessory) (PBH 2800 RE) (see figure C)
– Screw the SDS-plus adapter shank 22 into a
key type drill chuck 21. Secure the key type
drill chuck 21 with the securing screw 20.
Please observe that the securing screw has
a left-hand thread.
1 609 929 T39 | (19.11.10)
Inserting the Key Type Drill Chuck or the Key-
less Chuck (see figure D)
– Clean the shank end of the adapter shank
and apply a light coat of grease.
– Insert the key type drill chuck 21 or the key-
less chuck 23 with the adapter shank into the
tool holder with a turning motion until it au-
tomatically locks.
– Check the locking effect by pulling the key
type drill chuck or the keyless chuck.
Removing the Key Type Drill Chuck or the Key-
less Chuck
– Push the locking sleeve 5 toward the rear
and pull out the key type drill chuck 21 or the
keyless chuck 23.
Removing/Inserting the Quick Change
Chuck (PBH 3000-2 FRE)
Removing the Quick Change Chuck
(see figure E)
– Grasp the lock ring of the quick change
chuck 6 and pull it firmly in the direction of
the arrow. The quick change chuck is re-
leased and can be removed toward the front.
– After removing, protect the replacement
chuck against contamination.
Inserting the Quick Change Chuck
(see figure F)
– Before inserting, clean the quick change
chuck and apply a light coat of grease to the
shank end.
– Grasp the SDS-plus quick change chuck 2 or
the quick change keyless chuck 1 completely
with your hand. Slide the quick change chuck
with a turning motion onto the drill chuck
mounting 24 until a distinct latching noise is
heard.
– The quick change chuck is automatically
locked. Check the locking effect by pulling
the quick change chuck.
Bosch Power Tools