Sharpening Blades; Troubleshooting - VOSS.farming 85290 Handbuch

INSTRUCTION MANUAL VOSS.FARMING EASYCUT PRO
9.2

SHARPENING BLADES

CAUTION
The sharpening of the blades may only be carried out by specialist dealers using
specialist equipment. Do not sharpen the blades yourself.
10

TROUBLESHOOTING

NOTICE
► Do not make any improper changes or modifications to the unit.
► Never open the housing. Liability and warranty claims are excluded in the
event of repairs carried out by yourself, improper connection or incorrect
operation. Contact the manufacturer for repairs.
If faults occur with the unit, even after following the below solutions, or other defects
are found, contact the manufacturer. The contact details can be found in chapter 14.
Fault/Problem
Motor does not run
Motor gets hot
Motor vibrates
Motor is very loud
Motor runs very
slowly
85290 | 11 | 2020 | V2
Motor
Cause
1. No current
2. Cable, Switch or
motor defective
1. Air filter clogged
2. Blade tension is too
high
3. Blade and/or head
are dry
4. Defective ball
bearing
1. Rotor runs out of
round
2. Bearings are worn
out
3. Fan wheel broken
Bearings seized up
1. Carbon brushes
worn out
2. Defective rotor or
stator
Solution
1. Check the socket and fuse used
and have them checked/replaced
by qualified personnel if necessary.
2. Contact the manufacturer.
1. Clean or replace the air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this
solves the problem
machine stops cutting, the blades
must be sharpened.
3. Lubricate the blades/ clipper head.
4. Contact the manufacturer.
Contact the manufacturer.
Contact the manufacturer.
1. Change the carbon brushes.
2. Contact the manufacturer.
DE
EN
EN
FR
IT
NL
SV
ES
PL
and the
27