Oiling Blades; Changing Blades - VOSS.farming 85290 Handbuch

INSTRUCTION MANUAL VOSS.FARMING EASYCUT PRO
7.3

OILING BLADES

Oiling your machine is essential for a good result. It also prevents overheating and
significantly extends the life of the blades and the machine. Therefore, a thin film of oil
must be applied to the moving parts of the head.
CAUTION
Keep your fingers away from the sharp edges
of the blades to avoid injury.
To oil the blades, drip the oil onto the shearing blades
and into the opening every 10 minutes (fig. 2).
NOTICE
► Make sure that the shearing blades do not
run dry.
► Only use special clipper oil for oiling.
7.4

CHANGING BLADES

A blade set consists of an upper blade and a larger, lower blade, the grinding sides of
which always rest on each other.
CAUTION
Keep your fingers away from the sharp edges of the blades to avoid injury.
1. Switch off the clipper and disconnect it from the power supply.
2. To release the tension on the blades, turn the tensioning nut (2).
The blades are loosened.
3. Turn the clipper over and place the clipper on a flat, stable surface.
The fixing screws (7) are at the top.
4. Loosen the fixing screws (7) using the enclosed
tool (fig. 3).
NOTICE
Do not remove the fixing screws (7) completely.
You can remove the old blades.
5. Make sure that the new blades, especially the
grinding sides, are free of dirt.
85290 | 11 | 2020 | V2
Fig. 2
Fig. 3
23
DE
EN
EN
FR
IT
NL
SV
ES
PL