Noise/Vibration Information; For Your Safety; Intended Use - Bosch PSB 700-2 RE Bedienungsanleitung

Noise/Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the ma-
chine are: sound pressure level 97 dB (A); sound
power level 108 dB (A).
uncertainty K = 3 dB.
Wear hearing protection!
The typically weighted acceleration is 13 m/s

For Your Safety

Read all instructions. Failure to
follow all instructions listed below
may result in electric shock, fire
and/or serious injury.
Additionally, the general safety instructions either
in the enclosed booklet or those added in the
centre of these operating instructions must be ob-
served.
SAVE THESE INSTRUCTIONS.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
securely than by hand.
Do not work materials containing asbes-
tos. Asbestos is considered carcinogenic.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Do not use a machine with a damaged
mains cable. Do not touch the damaged ca-
ble and pull the mains plug when the cable
is damaged while working. Damaged cables
increase the risk of an electric shock.
Connect machines that are used in the
open via a residual current device (RCD).
Wear hearing protection when working
with impact drills. Exposure to noise can
cause hearing loss.
Always use the auxiliary handle supplied
with the machine. Loss of control can cause
personal injury.
10 • 2 609 932 193 • TMS • 08.02.05
Measurement
2
.

Intended Use

The machine is intended for impact drilling in
brick, concrete and stone as well as for drilling in
wood, metal, ceramics and plastics. Machines
with electronic control and right/left rotation are
also suitable for screwdriving and thread-cutting.
Auxiliary Handle/Depth Stop
(see figure
The auxiliary handle can be mounted on the left
or right side of the spindle collar, using the wing
bolt 10.
The drilling depth can be set with the depth
stop 12.
For this, press the push-button for the depth-stop
adjustment 9, adjust the required drilling depth X
and release the push-button for the depth-stop
adjustment 9 again.
The ribbing on depth stop 12 must point upwards.
English - 2
Use suitable detectors to determine if util-
ity lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
Switch off the power tool immediately
when the tool insert jams. Be prepared for
high reaction torque which causes kick-
back. The tool insert jams when:
– the power tool is subject to overload or
– it becomes wedged in the workpiece.
Hold the power tool only by the insulated
gripping surfaces when performing an op-
eration where the cutting tool may contact
hidden wiring or its own power cord. Con-
tact with a "live" wire will also make exposed
metal parts of the power tool "live" and shock
the operator.
)
A