Declaration Of Conformity - Bosch psb 500 re Originalbetriebsanleitung

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
02.11.2010
Assembly
Before any work on the machine itself, pull
the mains plug.
Dust extraction (PSB 500 RA)
(see figures A F)
–
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– As far as possible, use a dust extraction
system suitable for the material.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Bosch Power Tools
Dr. Eckerhard Strötgen
Head of Product
Certification
Observe the relevant regulations in your
country for the materials to be worked.
Prevent dust accumulation at the work-
place. Dusts can easily ignite.
Use the dust/chip extraction only when
working concrete, brick and brickwork.
Wood or plastic chips can easily lead to clog-
ging.
WARNING Fire hazard! Do not work metal-
lic materials with the extraction device
mounted. Hot metal chips can ignite parts of
the extraction device.
To achieve optimum extraction results, please
observe the following notes:
– Pay attention that the extraction device faces
flush against the workpiece or the wall. This
also makes drilling at a right angle easier.
– When using the extraction device, always
work with the maximum speed.
– After reaching the desired drilling depth, pull
the drill bit out of the drill hole first and then
switch off the impact drill.
– Use the extraction device only with the filter
element 17 mounted, as otherwise
dust/chips could access the interior of the
power tool and cause damage.
– Check the condition of the filter element 17
regularly. Replace a damaged filter element
immediately.
– The dust protection ring 19 can wear, espe-
cially when working with large drill-bit diam-
eters. Replace the dust protection ring when
worn/damaged.
English | 19
2 609 005 111 | (2.12.10)