Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch GDB 2500 WE Professional Originalbetriebsanleitung

OBJ_BUCH-114-002.book Page 15 Tuesday, November 9, 2010 11:58 AM

Technical Data

Diamond Drill
Article number
Rated power input
Output power
Rated speed n
0
– 1. Gear min
– 2. Gear min
Drilling diameter
– optimum range
– possible range
Tool holder
Water supply
pressure (max.)
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured sound values determined according
to EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 89 dB(A);
Sound power level 100 dB(A). Uncertainty
K = 3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 61029:
Vibration emission value a
2
tainty K = 1.5 m/s .
Bosch Power Tools
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 61029 and
GDB 2500 WE
may be used to compare one tool with another.
Professional
It may be used for a preliminary assessment of
0 601 18P 7..
exposure.
The declared vibration emission level repre-
W 2500
sents the main applications of the tool. However
W 1450
if the tool is used for different applications, with
different accessories or poorly maintained, the
-1
440 vibration emission may differ. This may signifi-
-1
960 cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
mm 82–132
tion should also take into account the times
mm 32–212
when the tool is switched off or when it is run-
1 1/4" UNC,
ning but not actually doing the job. This may sig-
G 1/2"
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
bar 6
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
kg 11.8
/I

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
2
= 3 m/s , Uncer-
Leinfelden, 05.10.2010
h
English | 15
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 W83 | (9.11.10)