Auxiliary Handle - Bosch GBH 36 V-LI Compact Professional Originalbetriebsanleitung

During the charging procedure, the three green
LEDs light up one after the other and briefly go
out. The battery is fully charged when the three
green LEDs light up continuously. The three
LEDs go out again approx. 5 minutes after the
battery has been fully charged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.

Auxiliary Handle

Operate your machine only with the auxilia-
ry handle 16.
Rotating the Auxiliary Handle (see figure A)
The auxiliary handle 16 can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
– Turn the wing bolt for adjustment of the aux-
iliary handle 10 in anticlockwise direction
and set the auxiliary handle 16 to the re-
quired position. Then tighten the wing bolt
10 again in clockwise direction.
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 1.
– Press the button for the depth stop adjust-
ment 9 and insert the depth stop into the
auxiliary handle 16.
The knurled surface of the depth stop 1 must
face downward.
– Insert the SDS-plus drilling tool to the stop
into the SDS-plus tool holder 2. Otherwise,
the movability of the SDS-plus drilling tool
can lead to incorrect adjustment of the drill-
ing depth.
– Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drill-
ing depth X.
Bosch Power Tools
Selecting Drill Chucks and Tools
For hammer drilling, SDS-plus tools are required
that are inserted in the SDS-plus drill chuck.
For drilling without impact in wood, metal, ce-
ramic and plastic as well as for screwdriving,
tools without SDS-plus are used (e.g., drills
with cylindrical shank). For these tools, a key-
less chuck or a key type drill chuck are required.
Changing the Key Type Drill Chuck
To work with tools without SDS-plus (e.g., drills
with cylindrical shank), a suitable drill chuck
must be mounted (key type drill chuck or key-
less chuck, accessories).
Mounting the Key Type Drill Chuck
(see figure C)
– Screw the SDS-plus adapter shank 19 into a
key type drill chuck 18. Secure the key type
drill chuck 18 with the securing screw 17.
Please observe that the securing screw has
a left-hand thread.
Inserting the Key Type Drill Chuck
(see figure D)
– Clean the shank end of the adapter shank
and apply a light coat of grease.
– Insert the key type drill chuck with the adapt-
er shank into the tool holder with a turning
motion until it automatically locks.
– Check the locking effect by pulling the key
type drill chuck.
Removing the Key Type Drill Chuck
– Push the locking sleeve 4 toward the rear
and pull out the key type drill chuck 18.
English | 23
1 619 929 797 | (3.2.09)