Auxiliary Handle; Changing The Tool - Bosch PSB 530 RA Originalbetriebsanleitung

Cleaning the Extraction Device (see figure A)
Attach the locking latch 17 or empty the dust col-
lector 15 before placing down the extraction de-
vice.
The dust collector 15 is sufficient for approx. 20
drillings with a drilling diameter of 6 mm.
When the extraction force diminishes or when
the level indicator 20 is full, the dust collector 15
must be emptied. For this, press on the riffled
surface of the release button 14 and take off the
dust collector 15.
Empty and clean the dust collector 15. Clean the
filter element 19 by gently striking or tapping
against it.
Check the filter element 19 for damage and re-
place it as required.
For this, as an example, pry off the holder of the
filter element 19 ( ) and change the filter ele-
ment 19 including the holder ( ). When placing
on the holder again, make sure that the rubber
gasket is inserted.
Reattach the dust collector 15 again and lock it
by pressing against the smooth surface of the re-
lease button 14.
Removing the Extraction Device
For removal of the extraction device 9, push the
release button 18 to the right or left and pull off
the extraction device 9 toward the front.

Auxiliary Handle

Operate your machine only with the auxiliary
handle 11.
The auxiliary handle 11 can be set to any position
for a secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxiliary
handle 10 in anticlockwise direction and set the
auxiliary handle 11 to the required position. Then
tighten the wing bolt 10 again in clockwise direc-
tion.
Adjusting the Drilling Depth
(PSB 530 RA/PSB 650 RA) (see figure B–C)
With the extraction device mounted, the drilling
depth "X" can be adjusted.
Bosch Power Tools
Insert a drill bit into the drill chuck and clamp the
drill bit, see section "Changing the Tool",
page 21. Rotate the collar for the depth stop 13
upward until it can be moved on the telescopic
guide 12. Place the machine, without switching it
on, firmly against the surface to be drilled until
the drill bit touches the surface.
Read the scale value of the telescopic guide 12
on the collar 13. Add this value to the requested
drilling depth X. Slide the collar 13 to the calcu-
lated scale value and then rotate the collar 13
downward to lock the determined clearance.
Adjusting the Drilling Depth
(PSB 600 RE/PSB 650 RE) (see figure D)
The required drilling depth X can be set with the
depth stop 21.
Press the button for the depth stop adjustment
22 and insert the depth stop into the auxiliary
handle 11.
The knurled surface of the depth stop 21 must
face upward.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth X.

Changing the Tool

Keyless Chuck (PSB 600 RE/PSB 650 RE/
PSB 650 RA) (see figure E)
The drill spindle is locked by pressing the spindle
lock button 2. This makes quick and easy chang-
ing of the tool in the drill chuck possible.
Open the keyless chuck 1 by turning in rotation
direction , until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck 1 by
hand in rotation direction
tion ("click") is no longer heard. This automati-
cally locks the chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
English | 21
until the locking ac-
2 609 002 371 | (21.1.08)