Peavey TransTube 100 EFX Handbuch Seite 9

F F o o o o t t s s w w i i t t c c h h
EFX DELAY
MODULATION
CHANNEL
SELECT REVERB
TM
PFC 3
1
2 3
DOUBLE-CLICK
PRESET PRESET PRESET
MODE
TO STORE PRESET
28 29 30 31 32 33 34 35
M M O O D D E E S S E E L L E E C C T T
The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode. Pressing
the MODE SWITCH (28) selects between the two modes. The active mode is indicated by the
MODE LED (29). Illumination of the LED indicates EFX Select Mode; a dark LED indicates Preset
Select Mode. Controls and indicators 30-35 perform different functions relative to the active
mode.
P P R R E E S S E E T T S S E E L L E E C C T T M M O O D D E E
In this mode, all three switches control effects presets. Their corresponding LEDs indicate which
preset is active. Once desired settings are achieved utilizing the effects controls on the front
panel, d d o o u u b b l l e e - - c c l l i i c c k k o o n n e e o o f f t t h h e e P P r r e e s s e e t t s s w w i i t t c c h h e e s s ( ( 3 3 0 0 , , 3 3 3 3 , , o o r r 3 3 5 5 ) ) t t o o s s t t o o r r e e t t h h e e s s e e t t t t i i n n g g s s . . To return to the
last saved settings for a Preset, press the desired Preset switch once.
For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section
of this manual on the following page.
E E F F X X S S E E L L E E C C T T M M O O D D E E
N N O O T T E E : : When entering this mode, the current preset will remain active. In this mode, SWITCH 1
(30) selects between the Lead and Clean channels. The CHANNEL LED (31) will illuminate when
the Lead channel is active. SWITCH 2 (33) toggles between two effects and their respective
settings. This switch may be used as an on/off switch if one of the settings has no effects active.
To use the MODULATION LED (32) as a status indicator, the "off" (or lower setting) should be
made with the LED dark, and the "on" (or higher setting) made with the LED illuminated. SWITCH
3 (35) toggles between two reverb and delay settings. As with effects settings, this switch may be
used as an on/off for reverb and delay. Both functions change simultaneously when this switch is
depressed.
9