General Maintenance; Replacing The Cutting Blade - Powerworks 2500713 Bedienungsanleitung

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
MAINTENANCE
Before performing any maintenance, make sure the
mower battery and battery key are removed to avoid
accidental starting and possible serious personal injury.
To prevent accidental start-up or unauthorized use, the
cordless lawn mower is equipped with a removable
safety key. To completely disable the mower, the safety
key should be removed and kept in a place away from
the mower and out of the reach of children.
When servicing, use only authorised replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Keep the motor and battery compartments free from
grass, leaves or excessive grease. This will help reduce
the risk of fire.

GENERAL MAINTENANCE

Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc.
Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please call Powerworks customer service
for assistance. Avoid using solvents when cleaning
plastic parts. Most plastics are susceptible to damage
from various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove dirt,
dust, oil, grease, etc.
To reduce the risk of damage and danger, never clean
the tool with pressure washer or under running water.
Store indoors only. Always remove the battery from
mower and charger when cleaning or storing the tool.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
Periodically check all nuts and bolts for proper tightness to
ensure safe operation of the mower.
Wipe the mower clean with a dry cloth occasionally. Do
not use water.
LUBRICATION
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further bearing lubrication is required.
Always protect hands by wearing heavy gloves and/or
wrapping the cutting edges of the blade with rags and
other material when performing blade maintenance.
Contact with the blade could result in serious personal
injury.
Do not lubricate any of the wheel components.
Lubrication may cause the wheel components to fail
during use, which could result in serious personal injury
to the operator and/or mower or property damage.

REPLACING THE CUTTING BLADE

See figure 11-12.
NOTE: Only use authorised replacement blades. Replace
worn or damaged blades and bolts in sets to preserve
balance.
■ Stop the motor and remove the battery key. Allow
blade to come to a complete stop.
■ Remove the battery pack.
■ Turn the mower on its side.
■ Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
■ Loosen the blade bolt by turning it counterclockwise
(as viewed from bottom of mower) using a 27 mm
wrench or socket (not provided).
■ Remove the blade bolt and blade.
■ Place the new blade on the shaft. Ensure blade is
properly seated with shaft going through center blade
hole and the two blade posts on the fan inserted into
5
WARNING
WARNING
WARNING