Technical Specifications - Velleman CAMSET26 Bedienungsanleitung

• Make sure the vehicles' engine is off and power is removed from the electrical
system. Disconnect the battery and remove the ignition key from the ignition
switch.
• Mount the LCD [A] with the mounting bracket [B] on the dashboard using the
double sided tape on the bottom of the bracket. Make sure the driver has a
clear view on the monitor.
• Connect the monitor cable [D] to the monitor. The connector fits in only one
way, do not force.
• Guide the video cable [C] to the back of the car where the camera will be
mounted.
• Mount the camera in the desired location on the back of a truck, camper, all-
terrain vehicle... (mounting accessories not included).
• Drill a hole (Ø20mm) in the coachwork (drill not included).
• Insert the cables [5, 6] of the camera [F] into the hole. Place the rubber
sealing ring inside the hole to prevent water from entering the vehicle.
• Connect the video cable [C] to the camera [5, yellow]; connect the other end
to the monitor cable [D2, yellow].
• Connect the red wire [3] of the monitor cable [D] to the cars +12V electrical
circuit, at a location where there is only power once the ignition key is turned
(run circuit).
• Connect the black wire [4] of the monitor cable [D] to ground (GND).
• Connect the red wire [3] of power cable [E] to the reverse light circuit (+12V).
• Connect the black wire [4] of power cable [E] to ground (GND).
• Connect the other end of power cable [E] to the camera [6, black].
• Restore power to the vehicles' electrical system; insert the ignition key in the
ignition switch and turn.
• The monitor will now show the image of the camera.
6.

Technical specifications

system
monitor size
number of pixels
video inputs
camera pick-up element
synchronization
video output
horizontal resolution
IR LEDs
min. illumination
lens angle
S/N ratio
video input signal
A/V input connections
power supply
max. current
cable
operating temperature
dimensions monitor
camera
29/09/2010
CAMSET26
NTSC
3.5" TFT
480(H) x 320(V)
1
1/4" colour CMOS
internal
mirror image
420 TV-lines
8
0 Lux when IR on
120°
>= 48dB
1.0Vpp composite video signal at 75 ohm
RCA connector
DC 12V ±1.5V
300mA
1x monitor cable (±2m), 1x power cable (±1.5m), 1x
video cable (±6m), 1x camera cable (±1.5m)
-20°C ~ +60°C
93 x 102 x 45mm
75 x 75 x 68mm
4 ©Velleman nv