Standby Mode - Plustek SmartOffice PN2040 Benutzerhandbuch

Calibrate the scanner if colors appear in areas that should be white, or colors of
the scanned image and the original vary a lot. This allows you to adjust and
compensate for variations that can occur in the optical component over time by its
nature.
The following describes how to calibrate the scanner:
1. The Calibration Sheet is used specially for ADF Scanning calibration.
2. Insert the special calibration sheet into the ADF of the scanner.
Attention
3. Click Start > All Programs > Your scanner model name > Calibration
Wizard.
4. Click Next from the Calibration Wizard that pops up and then click Calibrate
Now.... Start to begin the Flatbed Reflective calibration process. After the
calibration is complete, click OK.
5. Click Calibrate Now.... Click on the Start button to begin the ADF calibration
process.
6. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK and then
click Finish.
S M
TANDBY ODE
To save power consumption, the scanner will enter the standby mode after it is idle
for a while. You may disable the standby mode or define an idle time for the scanner to
automatically enter the standby mode.
Please insert the special calibration sheet
included with the scanner. Alternatively you may
also use any plain white sheet of paper sized in
A4 (216 by 297 mm) instead; however, the
calibration effect may be less good than the
special calibration sheet.
36