Installing An Expansion Card - ASROCK K8SLI-eSATA2 Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

PCI Slots: PCI slots are used to install expansion cards that have the 32-bit PCI

interface.

PCIE Slots: PCIE1 (PCIE x 16 / x 8 slot) is used for PCI Express cards with x16

lane width graphics cards.

PCIE2 (PCIE x 1 slot) is used for PCI Express cards, such as

Gigabit LAN card, SATA2 card, etc.

PCIE3 (PCIE x 1 / x 8 slot) is used to install PCI Express expansion

cards. For the information of the compatible SLI

press VGA cards, please refer to the "Supported PCI Express VGA

Card List for SLI

tings on page 13 for different functions.

PCIE3 slot is intended for SLI

one PCI Express VGA card to this motherboard, please install it to

PCIE1 slot.

Installing an expansion card

Step 1.

Before installing the expansion card, please make sure that the power

supply is switched off or the power cord is unplugged. Please read the

documentation of the expansion card and make necessary hardware

settings for the card before you start the installation.

Step 2.

Remove the system unit cover (if your motherboard is already installed in

a chassis).

Step 3.

Remove the bracket facing the slot that you intend to use. Keep the

screws for later use.

Step 4.

Align the card connector with the slot and press firmly until the card is

completely seated on the slot.

Step 5.

Fasten the card to the chassis with screws.

Step 6.

Replace the system cover.

1 2

ASRock K8SLI-eSATA2 Motherboard

Mode" on page 8. Please check the jumper set

function. If you plan to install only

Mode PCI Ex

Inhaltsverzeichnis